Bespoke livery: a Daytona that belongs to one car
Rolex will never build you a Daytona in the colours of your car. We will. What a livery commission changes, what it leaves alone, and the five dials we built to show how far it can go.

Most watches are finished before you meet them. A livery commission starts the other way round: with a car, a colour, and a conversation.
We build these from a standard Daytona. The brief is always the same — make the watch belong to one particular car, and stop before it becomes a novelty. Below is how it works, and the five pieces we finished to show the range.
What actually changes
Three surfaces, in this order of importance.
The dial. This is where a commission lives or dies. A single ground colour, then the counters either matched, inverted, or left alone. The printing stays where Rolex put it; we do not add names, crests or signatures to a dial.
The counters and the accents. One accent colour, used once. The moment a second accent appears, the dial stops reading as a Daytona from across a table.
The bezel and the case flanks. The quietest of the three. A softened tone, a brushed finish, a single engraved line at the back if you want the car recorded somewhere only the wearer sees.
What never changes
The movement, the case geometry, the bracelet, the crystal, the reference. A commission is a finish, not a rebuild. If someone offers you a “custom Daytona” with a different movement, you are not being sold a commission.
Five cars, five dials
Each of these started as a 116500 and ended somewhere different. They are here to be looked at rather than copied — the point of a commission is that yours does not exist yet.
- The blue-and-white one. A pale ground with two cold counters. The most restrained of the five, and the one most people would wear daily.
- The silver-and-red one. Warmer ground, one red accent, no second colour anywhere. Reads almost like a standard dial until you are close.
- The deep-ground one. Dark dial, bright counters. The loudest of the set, and the one that photographs best.
- The two-tone one. A split ground that follows the line of the sub-dials rather than the centre of the dial. The hardest to execute, because the split has to land identically on both sides.
- The monochrome one. Everything in one family of grey. If you want a commission nobody notices, this is the one.
How a commission runs
One. You send the car — a photograph, a paint code, or just the name of the colour you keep coming back to.
Two. We come back with two or three dial proposals. Not ten. Ten means we have not understood the brief.
Three. You approve a physical sample before anything is finished on your watch. Colour on a screen lies; colour on a dial does not.
Four. The work is done, the watch is photographed as it leaves, and you get the images before it ships.
Time depends on the dial work, not on the watch. A single-colour ground is quick; a split ground or a matched set of counters takes longer, because each element is finished and checked separately.
The paperwork, honestly
A livery commission has no co-branded certificate, because there is no co-brand. Rolex has never released a Daytona signed by a car maker, and anyone telling you otherwise is selling a story rather than a watch. What you get is the original reference, its own papers where they exist, and our record of the work done.
That is the trade: no official collaboration, and a watch that does not look like the one on the next wrist.
If you want one
Send us the car. We will tell you honestly whether it makes a good dial — some colours do not survive being reduced to 40 millimetres, and we would rather say so before you commission it than after.
